This remote was used for a 1998 Millenia S. I don't have the car anymore so I don't need the remote. If you have a Millenia and need the remote it can be reprogrammed for your car. Dealers want as much as $125 for remotes. I'm asking $40 which is a little less than you'll find used remotes for on ebay once you factor in shipping ($35US + about $15 US shipping). This remote is a keylessride remote and the FCCID is SRW-KRVAR001.

Here are the programming steps I followed when I bought the remote 2 years ago:

Step 1: Open the driver's side door, and then press the LOCK button (on the door)
so ALL the doors lock and the security light comes on.

Step 2: Unlock the drivers side door by turning up the Un-Lock switch manually
(the one on the door that has the RED Spot on it) for the DRIVER's DOOR ONLY on
the door so the security light now turns off. You'll sound off the Alarm if you don't


Step 3: Insert your key in the ignition and turn it to ACC position, and then take
out the key. Repeat this two times. (remember to take the key completely out!)
For a total of THREE times.

Step 4: Press the Door Switch THREE times. This switch is located on the door jam.
(BE SURE THE DOME OR DOOR COURTISY LIGHT GOES OUT WITH EACH
DEPRESSION OF THE SWITCH) The car should now beep once.

Step 5: Press any button on the remote twice. The car should beep once again.

Step 6: Repeat STEP 5 on each remote till ALL the remotes you have/want
programed.

Step 7: Wait about 5 seconds and then the car should beep four times.

Step 8: Press the Un-Lock button (on the door) and NOW your remote is
programmed!

Step 9: TEST ALL KEY FOBS FOR PROPER PROGRAMMING AND FUNCTIONALITY.