Anyone feel like these are factory seconds.
The back edge of mine is uneven with discoloured bumps all along it’s length.
The back edge of mine is uneven with discoloured bumps all along it’s length.
Sep 16th, 2018 12:08 pm
Sep 16th, 2018 12:34 pm
That is normal for Mora's. Nothing to be concerned with.dookiemoore wrote: ↑Sep 16th, 2018 12:08 pmAnyone feel like these are factory seconds.
The back edge of mine is uneven with discoloured bumps all along it’s length.
Sep 16th, 2018 1:44 pm
Maybe I was lucky but my six other Mora’s aren’t as bad as this.
Sep 17th, 2018 1:20 pm
The few I ordered are all like this. Nothing to be worried about.dookiemoore wrote: ↑Sep 16th, 2018 12:08 pmAnyone feel like these are factory seconds.
The back edge of mine is uneven with discoloured bumps all along it’s length.
Sep 17th, 2018 1:26 pm
Sep 17th, 2018 1:47 pm
Sep 17th, 2018 2:02 pm
Sep 17th, 2018 7:27 pm
I think I was pretty clear in my last post that I was satisfied given it was a cheap knife and beater for my toolbox and wouldn’t be returning it regardless.Kurtz7834 wrote: ↑Sep 17th, 2018 1:20 pmThe few I ordered are all like this. Nothing to be worried about.
This is not a "pretty" knife for collectors, it's a hard use knife for woodsman, tradespeople etc.
It's under $15, has great blade steel, holds an edge,comfy handle, and cuts like a laser. Not sure what else you wanted or expected.
Sep 17th, 2018 8:04 pm
Sep 17th, 2018 8:52 pm
How easy is this to use for someone who's never used a sharpenerKurtz7834 wrote: ↑Sep 6th, 2018 8:59 amI really like the Lansky turnbox.
https://www.amazon.ca/Lansky-4-rod-Croc ... 000B8FW0E/
![]()
Sep 17th, 2018 9:10 pm
very easy. hold the blade vertical @90 degrees (ie. as vertical as possible) & run the whole length of blade through the ceramic rods. IMO this system is good for maintenance rather than resharpening a really dull or damaged blade.
Nov 22nd, 2018 11:52 am