Answered.

[DJ Trance AZ]

Answered.

[EP32k2]

Nope, not TSX at all. TSX will look simular to this without the blue cutoff.

[DJ Trance AZ]

Answered.

[VorteC]

Yeah they're not the TSX projectors, I had the TSX and I've sold TSX projectors too. EP posted a pretty good picture of what the TSX cutoff would look like.

[boredstudent3]

not only did u not get a tsx projector, but ur cutoffs are not aligned...the right one is tilted too much

[aricebox]

does not look like a good job.....do you mind posting where you got this done?

[l69norm]

Uh oh...well also my projector uses H1 bulb. I installed a pair yesterday and it just doesn't sit flush even when I matched the nipples on two surfaces, exposing part of the bulb @ the back of the projector.

TSX uses a D2S bulb, not H1:
D2s:
http://forum.geceucusu.com/uploads/p...1176285634.jpg



The back of a TSX looks like:

http://faqlight.carpassion.info/imag...ctor-sizes.jpg



I'm not sure if you trying to put a HID kit H1 bulb into a TSX projector? (You have to use a real D2s bulb)

Can you show us a photo of the projectors that you got?

[DJ Trance AZ]

I found this site:
http://www.auto-electronic.net/hidprojector.htm

http://www.auto-electronic.net/TSX-H...-Projector.htm

The North American agent is The Retrofit Source. My TSX H1 does look like the one from the site cited above.

[l69norm]

I found this site:
http://www.auto-electronic.net/hidprojector.htm

http://www.auto-electronic.net/TSX-H...-Projector.htm

The North American agent is The Retrofit Source. My TSX H1 does look like the one from the site cited above.

It looks like you have a chinese clone/replica of a TSX projector. I haven't seen any reviews of TSX clones (I didn't know they existed) , but here is a review of the FX clone that the same company also sells:
http://www.hidplanet.com/forums/view...ht=tsx+replica

As you can see, the FX clone not exactly the same as OEM FX projector. They copy some of the original defects in the OEM design plus add in a few new ones.

It's also possible that those black triangles could be caused by your H1 kit bulbs which might be off center. You can try spacing the bulbs back/forth side/side, rotated, etc to see if you can get better results.

I would try asking on the Retrofit source or HIDplanet forums

[DJ Trance AZ]

Answered.

[BeaverLiquor]

i hope i don't have to drive anywhere near you at night.

[alex_d10]

Why dont you complain to the seller? I'm pretty sure that all OEM hid projectors use D2S bulbs, so that H1 bulb is already a dead giveaway...

[DJ Trance AZ]

Answered.

[afzan]

i hope i don't have to drive anywhere near you at night.

agreed

[MP3_SKY]

i hope i don't have to drive anywhere near you at night.

I've seen worse, at least those aren't the HID kit with horrible glare.