Speaker RING HELP!!

[onecoolloser]

Hey guys.

I have two speaker rings that pulse to the beat. It's used in cars. I dont know how to set them up. If any of you have these and know how to set them up, please help.

I have two rings with the the same wire (lets call it Wire A)
I have a (i think power) adapter with a pair of RED/BLACK wires AS WELL as one pair of Wire A
I have another device, maybe the controller, which has PULSE/ON/OFF and a Volume knob. This has TWO pairs of wire that looks like SPEAKER wires.

So...guru's...help, please.

Also, I have no need for them, i'll sell them to one of you guys if you want. I think that these are 8" rings.

Here is a picture. Pls dont laugh at my photoshopping

[gq_fuzion]

its hard to tell from the picture... but i have a light bar that pusles to the music and the unit that has the knob on it is the sensor unit

1 set of wires from the sensor unit would be going to the lights, and other set of wires to power...

i'm assuming that the extra block you have with the 4 wires come outta it would be a distributer... therefore the power coming from the sensor unit, would go to the distributer, which would distribute it to each light ring...

now don't quote me on this.... cause i can't tell with a picture like that....

[onecoolloser]

So you think that one of the wires that look like speaker wire would go to power?

Is there a positive/negative thing to this? None of the units have markings...what if i connect negative from one of the rings to positive on the other? Would i be screwed? Will the neon burn my car down?