Expired Hot Deals

Best Buy

[Best Buy] HOT $299.95 for ANYCUBIC MEGA-S

  • Last Updated:
  • Nov 9th, 2020 12:56 pm
[OP]
Newbie
User avatar
Dec 1, 2016
22 posts
17 upvotes

[Best Buy] [Best Buy] HOT $299.95 for ANYCUBIC MEGA-S

Seems like a good deal for an AnyCubic printer under $300 bucks, there is $100 off.

It will end this month. The size is around 8 by 8 inches.

A pretty high price on Amazon for the same model.

BestBuy price: $299.95


Amazon Price:
$389.99
https://www.amazon.ca/ANYCUBIC-Mega-S-E ... r=8-8&th=1
$354.99
https://www.amazon.ca/ANYCUBIC-Printer- ... NrPXRydWU=


That's the best deal I find for ANYCUBIC MEGA-S。
Images
  • M1.png
  • M2.png
  • M3.png
Last edited by djjh62 on Nov 5th, 2020 4:30 pm, edited 1 time in total.
6 replies
Deal Addict
User avatar
Dec 31, 2007
2409 posts
393 upvotes
Thornhill
djjh62 wrote: FDM 3D printer from AnyCubic.

Printing volume reach 8.27 x 8.27 x 8.07 inch

BestBuy price: $299.95


Amazon Price:
$389.99
https://www.amazon.ca/ANYCUBIC-Mega-S-E ... r=8-8&th=1
$354.99
https://www.amazon.ca/ANYCUBIC-Printer- ... NrPXRydWU=


That's the best deal I find for ANYCUBIC MEGA-S。
I have 3 of these printers and 1 of their newer Mega-Pros. Have been using them for some time now and have had very little issues with them. Good price for sure, thanks OP. Just a reminder, usually no tax is charged on Amazon.ca for these printers, so keep that in mind.
Jr. Member
Aug 13, 2004
139 posts
133 upvotes
Montreal
Did you have issue with prints coming off the bed? I see some cable from the bed. is it heated bed?
Newbie
Nov 30, 2019
78 posts
26 upvotes
Does this require bed leveling or is it plug-and-go?
Member
Nov 2, 2007
341 posts
68 upvotes
fatdad wrote: Does this require bed leveling or is it plug-and-go?
I could not get mine level but couldn’t find any warpage anywhere. After doing everything recommended I installed the custom firmware that allows multipoint calibration and it’s been great since.
[OP]
Newbie
User avatar
Dec 1, 2016
22 posts
17 upvotes
ZERO does not have the hotbed, that is not a good one

Top

Thread Information

There is currently 1 user viewing this thread. (0 members and 1 guest)